Shrink chuck 4,5° PSK 50 - 10 - 75

Shrink chuck 4,5° PSK 50 - 10 - 75Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of

- Longer-lived than standard collets

With built-in tightening bolt

Low-vibration boring bars

Collets sealed with seal for IC DIN 6499 B (ISO 15488 B) ER-system

Toolholders suitable for induction-

- Higher repeat-accuracy

5 with h4-tolerance and Ø 6 – Ø 32 with h6-tolerance

High flexibility: Large holding capacity up to –1 mm

For the inspection of machine tools according to ISO recommendation R230 or for testing the tool spindle

Improves chip evacuation and decreases the risk for chip jamming

For clamping tools with Morse taper shank and thread according to DIN 228-1 form A

thin thread and pitch diameter oversize