Shinwa 12" Aluminum Cutting Ruler with non-slip back

Shinwa 12" Aluminum Cutting Ruler with non-slip backThis aluminum cutting rule from Shinwa has an edge that is designed to be used as both a low cost 12" ruler and also to function as an edge to use a knife against when cutting veneer, paper, leather or other thin materials. It is wider (35mm) than a typical ruler so that fingers can be kept away from the cutting and there is a non slip pad on the backside to help prevent movement when cutting or drawing a line. The straightness tolerance is better

which translates to an flatness along the total length of better than 2

Richter chisel handles are made from domestic sustainably harvested European Ash known for its strength

but cut somewhat faster because of the square cut teeth

including rasps

0 x 75 809351 4

This Radius Plane is curved both along and across its sole

but at least one of our customers has commented that the knife was not supplied with a very sharp edge and required honing before it was really sharp

Enjoy drawing single

The focus can be adjusted by turning the black ABS ring and there is a 10 mm square opening with length markings which allow measurements to be made optically

3 (smooth) cut which gives a medium finish for rasps

A very good value in a precision ruler with graduations in 1/32" and 1/64" scales and 1 mm and 0

It also has corresponding steps for chisel angles using the lower blade clamp